• Be sure the table/floor you are placing this
appliance can bear its weight
• Installation only in a location which is pro-
tected against cross aeration / air draft
• Convection air slots and rear ventilations
of the appliance shall nog be covered /
obstructed
• Do not put any flammable items on top of
the appliance
• This product can NOT be fixed to a wall of
roof
USAGE METHODS
Assembly of the appliance
FFB 105 (Fig.1)
Parts List:
• Fireplace body 1x
• 0.5L burner 1x
• Extinguish cover 1x
• Tempered glass 2x
1. Unpack the fireplace and accessories. Check the content for completeness
and any damages incurred in transit. Keep children away from the packing.
2. Only install or place on a solid floor of non-flammable material
3. Remove all packaging and information material before assembly
4. Read warning sticker covering the burner, then remove the sticker
5. If something is broken or damaged: do not use the appliance. Return the
appliance to your store immediately.
6. Insert the glass into the intended slot (2x)
7. Place the burner into the burning chamber of the fireplace body.
FFB 830
(Fig.2)
Parts List:
• Fireplace body 2x
• 0.5L double-layer Burner 1x
• Control tool 1x
• Screws (5 x 30mm) 4x
• Tempered Glass 2x
• Screw (M6 x 10) 6x
• Screw cap 6x
4
22
To Next Page
Loading...
Need help?
General
