6
TD-001571-01-B
S
The CP Series loudspeakers are not designed to be suspended with eyebolts. However, the optional Yoke bracket can be mounted to a
suspended fixture.
OPERATION
C
This is a powered loudspeaker, containing an internal power amplifier that produces heat. Allow a minimum of 6 inches (152 mm) clearance
at cabinet back for convection cooling. Keep anything that might restrict airflow away from the rear of the enclosure (i.e draperies, walls,
etc.)
CAUTION! Do not install enclosures with their rear panels exposed to direct sunlight. Direct sunlight will
heat the amplifier module and reduce its ability to produce full output. Maximum ambient temperature for full
performance to specification is 35° C (95° F). Do not install enclosures in locations that are exposed to rain or
other water sources. The enclosure is not weatherproof. Outdoor installations must provide protection from the
elements.
AC M
Refer to Figure 8
Connect the AC power cord to the socket on the back of the amplifier. Make sure the plug is
fully inserted into the socket on the power amplifier module.
NOTE: Make sure that the AC power switch is in the OFF position before
connecting AC power cord to the AC source.
Connect the AC Power cord to the facility’s AC outlet.
If the QSC-supplied cord is lost or damaged, a standard 18-gauge IEC power cord may be
used. Replacements are available from QSC.
The CP Series loudspeakers are equipped with a universal power supply that can use input AC
power voltages ranging from 100–240VAC at 50 – 60 Hz.
WARNING! Use only the power cable that is correct for your
location.
AC Mains Disconnection
Push in on the bottom of the rocker switch to turn the powered loudspeaker off. Unplug the AC cable from the power source. Unplug the
cable from the amplifier.
Power Switch
Push in on the top of the rocker switch to apply AC mains power to the amplifier.
Rear LED POWER Indicator
The green LED POWER indicator on the rear panel will illuminate when AC Power is applied (AC cord connected, power switch on). The rear
LED POWER indicator will extinguish when AC Power has been removed.
If the rear LED POWER indicator does not illuminate within the first 15 seconds after power is applied, verify the AC mains line cord is properly
attached to the loudspeaker and plugged into the AC outlet. Verify the AC outlet is functioning properly.
NOTE: If the AC mains cord is usable and the AC mains outlet is operating properly, but the unit fails to operate, the
loudspeaker may require servicing. Contact QSC’s Technical Services department.
— Figure 8 —
To Next Page
Loading...
Need help?
General
