Scalar i6 QUICK START
The Scalar i6 features simple, cartridge-based media handling with active vault and Extended Data Life
Management (EDLM) partitions that automatically scan media for certain issues. For complete documentation,
including pre-installation requirements, refer to the Scalar i6 Documentation Center:
http://quantum.com/scalari6docs.
Activate your warranty and register your product with Quantum: www.quantum.com/startup
Your system will include a single Control Module, or a Control and at least one Expansion Module (EM).
Installing the Scalar i6
A summary of the steps is below. For details, see:
Install > Single Module Installation or Install > Multi-Module Installation.
For safety information, see Resources > Safety Information.
Step 1 Unpack the library, and remove the top cover and restraints.
Step 2 Multi-module installation only: Remove the robot and
the bottom cover; then install the bottom cover on the
bottom module of the library.
Step 3 Mount the library in the rack. For specifications, see
“Rack” in the Technical Specifications section of the
Site Planning Guide.
Step 4 Multi-module installation only: Add EMs, and install the
robot and the top cover.
Step 5 Install components, and cable the library.
Step 6 Connect to the WebGUI, and install the firmware.
Page 1
Step 7 Log on, and run the Installation Verification Test (IVT).
Expansion Module
Control Module
Local User Interface (LUI)
Magazines
Magazine Eject Buttons
To Next Page
Need help?
General
