6-66561-02 Rev B, February 2014
*6-66561-02*
© 2014 Quantum Corporation. All rights reserved. Quantum, the Quantum logo, DLT, DLTtape, the DLTtape logo, SuperLoader,
Scalar, DXi, StorageCare, StorNext, GoProtect, and Vision are registered trademarks of Quantum Corporation and its affiliates
in the United States and/or other countries. All other trademarks are the property of their respective owners. Quantum
specifications are subject to change.
Scalar i40 and Scalar i80:
Tape Drive Replacement
Qauntum recommends that you remove and install tape drives with the library
power on. It is faster and keeps all non-affected drives and partitions active. To
do this, carefully follow the instructions below, to prevent data loss or damage
to the Scalar
®
i40 or Scalar i80 library.
The tape drive always resides in a drive sled, and together they are effectively
one unit. If you order a new or replacement tape drive, it will already be
installed in a sled.
Caution: Do not remove the tape drive from the drive sled.
Note: For multiple tape drive installs in which you are changing control paths,
install and verify the tape drives one at a time, rather than all at once.
To replace a tape drive in the library, refer to the following sections:
• Taking ESD Precautions on page 2
• Preparing Partitions and Control Paths on page 2
• Removing a Tape Drive from the Library on page 4
• Installing a Tape Drive on page 5
• Replacing a Tape Drive with a Filler Plate on page 7
To Next Page
Need help?
General
Weight and Dimensions
