Quantum Scalar i80 Replacement Manual

Quantum Scalar i40 and Scalar i80: Tape Drive Replacement
6-66561-02 Rev B
February 2014
Preparing Partitions and Control Paths 3
Replacing a tape drive that is
assigned to a partition with a
tape drive that has the same:
• Interface type (Fibre Channel
or SAS),
and
• Form factor (half-height or
full-height),
and
•Vendor
Install the replacement tape drive
in the same slot as the removed
tape drive.
There are no special instructions
unless the tape drive you are
replacing is the control path in a
partition with multiple tape
drives, and you want the
partition to remain online during
the replacement procedure.
In this case, select another tape
drive as the control path. From
the Web client, use the Setup >
Control Path menu path.
Replacing a tape drive that is
assigned to a partition with a
tape drive that has a different:
• interface type (Fibre Channel
or SAS),
or
• form factor (half-height or full-
height),
or
•vendor
• If the partition contains only
one tape drive, delete the
partition before removing the
tape drive, and then re-create
the partition after you install
the replacement tape drive.
• If the partition contains
multiple tape drives, and the
tape drive you want to replace
is not the control path, delete
the tape drive from the
partition.*
• If the partition contains
multiple tape drives, and the
tape drive you want to replace
is the control path, select
another tape drive as the
control path.** Then delete
the tape drive you want to
replace from the partition.*
*To delete tape drives from
partitions, select Setup >
Partitions from the Web client.
**To modify the control path,
select Setup > Control Path
from the Web client.
Type of Installation Instructions

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g