LUCCA M58 !
Owner’s Manual Page 8
and the pressure exceeds 2 bar in which case the temperature should be reduced by a few
degrees so it does not exceed 1.8 bar.
Advanced PID Settings
Warning - This section allows the user to change the machine from Fahrenheit to Celsius mode
as well as other advanced settings that can greatly affect the performance of the machine.
These settings have been calibrated
using specialized test equipment and
should not be changed unless the user
has a thorough understanding of how a
PID controller operates.
To get into the advanced programming
mode, with the machine turned off hold
down both left/right buttons
simultaniously and then turn the machine
on. Keep holding the left/right buttons
until the display reads F.01 and then
release the buttons.
Use the left button to cycle through parameters and then use the right button to select a
parameter to change. Then use the left/right button to change the selected parameter.
To save the new changes turn the machine off and then back on again.
F.02 Mode Setting - By default the F.02 setting has been set to 4 (15 amp mode) to give priority
to the coffee boiler. The setting can also be set to 6 (20 amp mode) to give power to both
boilers. This can be helpful if you are steaming larger quantities of milk and desire more steam
capacity. If you change the F.02 setting to 6 to power to both boilers, then both power switches
must be on for the machine to operate or neither boiler will heat up.
E1/E2 Offset Setting - The coffee boiler offset setting has been calibrated using a special
Scace device and should not be changed. The steam boiler offset setting is set to 0° by default.
It can be changed up to 5° to increase the steam pressure, but the pressure may vary at higher
elevations so make sure it does not exceed 2 bars of pressure or damage may occur.
Note - The PID controller and heating lights will turn off when the reservoir is empty.
To Next Page
Loading...
Need help?
General
