17
EN
AL3 700/1000/1500W - REV006A
17
MAINTENANCE
WARNING:
make sure the electrical power to the motor is switched off when working manually on the windlass. Carefully re-
move the chain or rope from the gypsy or the rope from the drum.
Quick
®
windlasses are manufactured with materials resistant to marine environments. In any case, any salt deposits on the outside must
be removed periodically to avoid corrosion and damage to the equipment.
The parts where salt may have built up should be washed thoroughly with fresh water.
Once a year, the drum and the gypsy are to be taken apart as follows:
DRUM VERSION
Use the handle (1) to loosen the bush (7); pull off the drum (6) and the top clutch cone (11); loosen the fixing screws (10) of the rope/
chain stripper (14) and remove it. Pull off the gypsy (12).
NO-DRUM VERSION
Use the handle (1) to loosen the bush (2) and the screws (5); to remove the gypsy cover (4); and the top clutch cone (11); loosen the fix-
ing screws (10) of the rope/chain stripper (14) and remove it. Pull off the gypsy (12).
Clean all the parts removed to avoid corrosion, and grease the shaft thread (21 or 22) and the gypsy (12) where the clutch cones rest (11
and 13) (use grease suitable for marine environment).
Remove any oxide deposits from the terminals of the electric motor and the contactor unit; grease them.
N°.
DESCRIPTION
1 Bent anchor winch lever
2 Chrome-plated “AL” clutch bush
3 O-ring
4 Gypsy cover
5 Screw
6 Stainless steel “AL” drum
7 Bush drum
8 O-ring
9 Insert for manual anchor weighing
10 Screw
11 Upper clutch cone
12A Gypsy 1000W 8mm - 5/16"
12B Gypsy 1000W 10mm - 3/8"
13 Bottom clutch cone
14 Rope/chain stripper stainless steel
15 Spring washer
16 Oil seal
17 Internal circlip
18 External circlip
19 Bearing
20 Oil seal
21 Short Shaft
22 Long shaft
23 Key
24 “AL” chain fall cover
25 Screw
26 Screw
27 Screw
28 Chain fall cover support
29 Mooring rope puller
30 Spring for pressure lever
31 Mooring rope puller pin
32 Pressure lever
33 Gypsy lock spring
34 Gypsy lock lever
35 Gypsy lock lever control
36 Lever lock control safety
37 Gypsy lock pin
38 Sensor
39 Base
40 Gasket / jig Aleph
41 Stud
42 Gearbox flange gasket Top TG50
43 Gearbox flange gasket Top TG60
44 Gearbox 1000W Quick TG50
45 Gearbox 1500W Quick TG70
46 Washer
47 Spring washer
48 Nut
49 Washer
50 Self-locking nuts
51 O-ring
52 Key
53 Electric motor 700W 12V
54A Electric motor 700W 24V
54B Electric motor 1000W 12V
54C Electric motor 1000W 24V
54D Electric motor 1500W 12V
54E Electric motor 1500W 24V
54F Motor casing watertight 700W
55A Motor casing watertight 1000W
55B Grommet 1000W
56 Terminal board cover 1000W
57 Screw
58 Bottom gasket 1000W
59 Bottom protec cover 1000W
60 Cable outlet
To Next Page
Loading...
Need help?
General
