Page 7
ALL ELECTRICAL WIRING SHOULD
BE DONE BY A QUALIFIED
ELECTRICIAN.
WARNING
WIRING
General Information
Adequate wiring and motor protection should
be provided for all stationary compressors.
Wiring used for other machinery should not be
used. A qualied electrician familiar with local
electrical codes in your area should be used. Size
supply wiring per NEC (National Electric Code)
requirements.
Electrical connections must be properly
grounded. Ground connections should
be connected at the grounding screw.
Overheating, short circuiting and re
damage will result from inadequate
wiring.
To reduce the risk of electrical hazards,
re hazards or damage to the compressor,
use proper circuit protection. Your
compressor is wired at the factory for
operation using the voltage shown. Connect
the compressor to a power source with the
correct breaker size.
WARNING
CAUTION
WARNING
Incoming power should be
connected to the posts
marked (LINE)
Do not make
connections on prewired posts
marked (MOTOR)!
Electrical
connections must be
properly grounded.
Ground connections
should be connected at a
grounding screw.
To Next Page
Loading...
Need help?
General
