Radial Engineering SHOTGUN User Manual

Radial Engineering Ltd. Shotgun™ User Guide
5
IMPORTANT SAFETY NOTICE: As you are the sole user of the Shotgun, you are entirely responsible for using ampliers, power supplies
and effects that are electrically approved by your local authority and are safe for use. If you are unsure of the status of your equipment,
please contact the manufacturer or dealer for details. As Radial Engineering Ltd. is unable to control what is being connected to the
Shotgun, you agree to take full responsibility for its safe use and agree that Radial Engineering Ltd. along with its staff and directors
shall not be held responsible in any way for damages of any kind other than those clearly detailed in the Radial Warranty. Should you
for any reason feel uncomfortable with the above statement, you should return the Shotgun before use to the dealer in the original
packaging for full credit within 7 days of purchase.
Start testing by connecting your guitar to input-1 and
your amp to output-1. Important note: output-1 is
the default output and should always be used.
It is not isolated in order to provide the audio with a
single ground path and should be connected to an
amplier with a proper electrical ground. For safety,
always test at a low volume before increasing the
levels. Turn up the volume on your amp. You should
be getting a nice clean signal. Add your second
amp by connecting it from the Shotgun’s output-2.
If you hear noise, try lifting the ground by pushing
the output-2 ground lift switch in the up position.
Repeat for any additional ampliers.
If you encounter noise,
try lifting the ground.

Radial Engineering SHOTGUN Specifications

General

Brand	Radial Engineering
Model	SHOTGUN
Category	Music Equipment
Language	English