marine SmartController
Note: For successful registration, ensure
that all other handheld units on your boat
are turned off. If you try to register a new
handset with others active, you will see a
REGISTRATION INCOMPLETE message.
To de-register a handset
At REGISTRATION, press SELECT.
If the SmartController is already
registered, then the display will read
REGISTERED TO BASESTATION. Press
DEREG to continue, or EXIT to cancel the
operation.
The SmartController will attempt to
commuicate with the basestation and de-register. When complete, the
display will read HANDSET NOT REGISTERED.
If the SmartController cannot communicate with the basestation then a
BASE NOT FOUND message will be displayed. It is still possible to de-
register the SmartController at this point by pressing SELECT. To leave
without de-registering, press EXIT.
Factory Reset
This option will clear all settings from the SmartController. Press and hold
the SELECT key for 2 seconds to activate the reset.
Note: A reset does not alter the registration status of the SmartController
CONTINUE
REGISTRATION
INCOMPLETE
SEE MANUAL
D7672-1
EXIT DEREG
REGISTERED
TO
BASESTATION
READY TO USE
D7670-1
To Next Page
Loading...
Need help?
General
