BEFORE YOU BEGIN
WARNING:
DO NOT USE NON-RAZOR
PARTS WITH YOUR RAZOR
ELECTRIC SCOOTER. The
scooter has been built to certain
Razor design specifications. The
original equipment supplied at the
time of sale was selected on the
basis of its compatibility with the
frame, fork and all other parts.
Certain aftermarket parts may
or may not be compatible and may
void your warranty.
Required Tools
Remove contents from box. Remove the packaging separators that protect the components from damage
during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may
have occurred during shipping. Because the scooter is 95 percent assembled and packed at the factory,
there should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY
OR MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for initial charge (see page 5 for charging information)
Battery Tray
2.
1.
Handlebar
Stem
Twist Grip Throttle
5 mm Allen Wrench
(Included)
Two (2) 4 mm Allen Wrenches
(Only E200S Included)
8 mm/10 mm/16 mm
Wrenches (Not Included)
Phillips Screwdriver
(Included)
(E200S Only)
Valve Extender
(Located in right
handlebar grip)
Bicycle-style tire pump for
schrader valve tires with
pressure gauge
(Not Included)
Product ID Locations:
See locations to the left
1. Handlebar Stem
2. Battery Tray
3. Charger
4. UPC Side of Box (not shown)
Charger
Plug
Charger
Port
3.
Charger
(Note: Charger design may
vary from one shown)
To Next Page
Loading...
Need help?
General
