1 Loosen the bolt from the collar clamp.
2 With a twisting motion, push and twist to slide the handlebars onto the fork.
3 With the front wheel pointed straight ahead and the handlebars square to the front
wheel, tighten bolt on the clamp as shown with a 5 mm Allen wrench. Tighten securely.
WARNING:
Check handgrips and end caps regularly for wear or damage, as they are designed to aid in gripping handlebars and to provide some protection against possible impact. Replace
immediately if worn, torn, damaged, or missing.
WARNING:
Do not attempt to thread the handlebar into the front fork thread. Tighten collar clamp securely.
WARNING:
Failure to properly install and tighten the collar clamp may cause the rider to lose control and fall. If you are having difficulty understanding these instructions, please contact Razor
Customer Service for assistance.
CHARGING THE BATTERY
Your electric scooter may not have a fully charged battery; therefore you must charge the battery prior to use. Be sure to charge the battery in a clean, dry location away from direct
sunlight, flames or sparks.
Initial charge time: 4 hours.
Recharge time: up to 3 hours, even if the light turns green. Recommended maximum charging time is 24 hours.
Always charge the battery immediately after riding.
Fully charge battery before storing for extended periods of time.
Unplug charger from the wall outlet when not in use.
Failure to recharge battery periodically may result in a battery that will not accept a charge.
Make sure the lights are OFF when product is not in use.
Run time: Up to 30 minutes of continuous ride time. Run time may vary depending on riding conditions, rider weight, climate, and/or proper maintenance.
Constant starting and stopping may shorten ride time.
Battery life can vary depending on proper maintenance and usage of the product.
Do not charge at or below 32°F (0°C).
To Next Page
Loading...
Need help?
General
