44
ASSEMBLY AND SET-UP
Attaching the Handlebars
Required Tool: 3 mm Allen Wrench (included)
Unfolding the Scooter for First Time Use
1 Pull and hold the pin out, then
press down the folding tab, and
finally raise the T-bar to unfold.
2 Plug in connector. Slide the stem
onto the front fork. Be careful not to
pinch wire.
1 Pull and hold the pin out, then press down the folding
tab, and finally raise the T-bar to unfold.
2 Lift T-bar until audible locking sound is heard. Pin and
tab should return to their original position.
3 Tighten the four (4) handlebar
screws securely with a 3 mm Allen
wrench (screws and tool included in
plastic bag).
WARNING: Keep fingers
clear of the pivoting mechanism
when folding or unfolding the
scooter. Make sure others are
standing clear.
To Next Page
Loading...
Need help?
General
