START
GUIDE
Choose Your Connections
Set Up Your TV
VIDEO
Quality Connects to... Cables needed (not included)
Audio
Video
R-AUDIO-L
Devices with Video (composite)
outputs, such as DVD Players,
VCRs, Satellite Receivers,
Cable Boxes, Camcorders, and
Digital Cameras
C R T T E L E V I S I O N
Devices with Y Pb Pr
(component) outputs, such as,
HD Receivers, Satellite
Receivers, Cable Boxes, DVRs,
and DVD Players
COMPONENT
(CVID) INPUT
Pr
Pb
Y
Component
Video
Audio
Jacks
COMPOSITE (VID) INPUT
R-AUDIO-L
Connect a Signal Source
Cable Box, Satellite
Receiver, or Wall Outlet
OUT TO TV
or
TV
(Back Panel)
Fig. 2
Fig. 1
Outdoor Antenna
Indoor Antenna
-OR-
ANTENNA/CABLE
INPUT
DIGITAL/ANALOG
TV
(Back Panel)
ANTENNA/CABLE
INPUT
DIGITAL/ANALOG
Connect your TV to cable; a cable box or satellite
receiver; or an antenna in order to receive TV
channels. Connect the cables as shown in the rst
or second connection.
If you’re connecting a cable box or satellite
receiver and it has Component jacks (Y Pb Pr),
connect the cable box or satellite receiver to your
TV using the Component jacks (CVID) for a better
connection.
Continue to Step 2, Set Up Your TV, on the back
page.
We help improve our environment by printing only this one page of instructions. The complete User’s Guide is available at the support section on
www.rca.com/television.
Español- Ayudamos a mejorar nuestro ambiente imprimiendo sólo esta página de instrucciones. La Guía de Inicio Rápido en Español y la Guía del
Usuario completa se encuentran disponibles en la sección de soporte en www.rca.com/television.
Français- Nous aidons à améliorer l’environnement en imprimant cette seule page d’instructions. Le Guide de démarrage rapide et le Guide de
l’utilisateur sont disponibles en Français dans la section du soutien, sur le site Web www.rca.com/television.
RCA and associated marks are trademarks of THOMSON S.A. used under license to TTE Corporation.
Manufactured under license from Dolby Laboratories.
www.rca.com/television
Remember: The Component (CVID) and the Composite jacks (VID) share the R/L Audio jacks shown above.
Note: If you’re not getting a picture while using the component connection (above), check the connected device (for example,
a Progressive Scan DVD player). You need to change the setting on the device from progressive to interlaced (480i). Refer to
the User’s Guide for more information.
Make your connection decision easier by taking a few minutes to review the jacks on your
new TV. Compare the jacks on the device you want to connect and see if the same jacks
are available on your TV. Then refer to the chart below to determine the best connection to
make.
For more information about connecting your TV to other devices, refer to the User’s Guide
that can be found in the support section on www.rca.com/television. Make sure you read the
safety information provided separately before you connect and operate your TV.
To Next Page
Need help?
Picture
