16
Delay Ring
Use this setting to delay the Central Office ring.
1. Press the Menu button while in standby mode.
2. Use the Vol (+ or -) buttons to scroll up or down to SET PHONE OPTIONS.
3. Press the Sel/Save button.
4. Use the Vol (+ or -) buttons to scroll up or down to SET DELAY RING.
5. Press the Sel/Save button.
6. Use the Vol (+ or -) buttons to scroll up or down to 0 ring up to 10 rings.
7. Press the Sel/Save button to save.
NOTE: The default Delay Ring is 0. If your system has a phone with the auto attendant ON, we
suggest that you set the Delay Ring to 2 rings. This allows the auto attendant to pick up the
incoming call before it rings in.
Phone ID
1. Press the Menu button while in standby mode.
2. Use the Vol (+ or -) buttons to scroll up or down to SET PHONE OPTIONS.
3. Press the Sel/Save button.
4. Use the Vol (+ or -) buttons to scroll up or down to SET PHONE ID.
5. Press the Sel/Save button.
6. Press the Sel/Save button again to automatically set the phone ID, or press any
memory button (1-16) to assign a phone ID.
NOTE: The Intercom indicator will flash red and blue if the ID is not programmed.
NOTE: The Phone ID (01-16) is unique. If you manually select a phone ID that belongs to
another unit on the system, NOT AVAILABLE shows in the display. Press Sel/Save or choose
another memory button.
NOTE: If the phone cannot find an ID, determine if there are too many phones connected to
the system. A maximum of 16 phones can be connected in the system at one time.
NOTE: You may press the Exit button at any time to exit , except during the ID search.
Programming the Telephone
To Next Page
Loading...
Need help?
General
