This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against h a r m f ul
interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
•
Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Este aparato cumple con la Parte 15 del Reglamento de la FCC. El funcionamiento de este equipo queda sujeto a las
dos condiciones siguientes: (1) este aparato no puede causar interferencia negativa, y (2) este aparato debe aceptar
cualquier interferencia recibida, incluyendo interferencias que pudieran ocasionar que el equipo funcione de una
forma que no sea la deseada.
Este equipo ha sido evaluado y se ha determinado que cumple con los límites establecidos para aparatos digitales
de clase B, de acuerdo a lo estipulado en la Parte 15 del Reglamento de la FCC. Estos límites se han diseñado para
proporcionar una protección razonable contra una interferencia negativa en instalaciones residenciales. Este equipo
genera, usa y puede irradiar energía de radiofrecuencias y, si no se instala o usa según indican las instrucciones, podría
provocar interferencia negativa en las comunicaciones radiales.
Noobstante, noexiste garantíade quenose produzcainterferencia enuna instalacióndada.Si esteequipo
efectivamente provoca interferencia negativa en la recepción de las señales de radio o de televisión, lo que se
puede determinar encendiendo y apagando el equipo, instamos al usuario a tratar de corregir dicha interferencia
sigueindo una o más de las recomendaciones siguientes:
• Reorientelaantenareceptoraopóngalaenunlugardiferente.
• Aumenteladistanciaentreelequipoyelaparatoreceptor.
• Enchufeelequipoenunatomadecorrienteconectadaauncircuitodiferentealcircuitoalqueestéconectado
el receptor.
•
Pidaayudaalvendedoroapersonaltécnicoexperimentadoenreparaciónderadiosytelevisores.
Quick Start Guide / Guía de inicio rápido
Advertencia:Eltomacorrienteseusacomodispositivodedesconexiónydebeestarsiempredisponibleparasu
funcionamientodurantesuuso.Paradesconectarcompletamenteeltomacorrientedelaredeléctrica,eltomacorriente
debeestardesconectadototalmentedelenchufedelaparedconectadoalaredeléctrica. El enchufe-salida debe
instalarse cerca del equipo y es fácilmente accesible.
Power on the tablet
Press and hold the power button 4~5
seconds
untiltheRCAlogoappears.
Encienda la tableta
Oprima y mantenga pulsado el botón
de encendido por 4 ó 5 segundos hasta
queellogoRCAaparezcaenpantalla.
When using the tablet for the first time, the Jumping
IconswillremindyoutopulluptheALLAPPsmenu.
Tap the UP arrow or swipe up from the bottom of the
screentoentertheALLAPPsmenu.
Cuando use la tableta por primera vez, los iconos que
saltanlerecordarándetener elmenú deTODAS LAS
APLICACIONES.
Pulselaecha ARRIBAodeslicedesdelaparteinferior
de lapantalla paraentrarenelmenúdeTODASLAS
APLICACIONES.
To wall outlet
Al tomacorriente
de la pared
* MicroUSBportforchargingateitherOFFmodeorStandbymode.
* PuertademicroUSBparacargaraomododeOFFomodedeEspera(Standby).
Charging time will vary depending on remaining battery life. Charging from 0%,
shouldtakeapproximately4-5hours. UseONLY theincluded ACadapterwiththe
small round port.Youmaynotbeabletoturnonyourtabletforatleast20minutesif
the battery was fully drained.
El tiempo de carga variará dependiendo de vida de batería restante. Cargando a partir
dela0%,debetardaraproximadamente4-5horas.UtiliceSOLAMENTEelincluidoCA
Adaptorconelpequeñopuerto redondo. Es posible que no pueda encender su Tablet
durante al menos 20 minutos si la batería fue drenada completamente.
IMPORTANT! Please Read.
We recommend fully charging your tablet before using it for the first time. For
optimumperformance,pleaseconnecttheprovidedACadaptertoyourtabletwhenit
falls below 20% charge.
¡IMPORTANTE! Favor de leer.
Lerecomendamosquecarguesutabletacompletamenteantesdeusarlaporprimeravez.
Paraunrendimientoóptimo,conecteeladaptadordeCAasutabletacuandolabatería
alcanze de 20% de carga.
Jumping Icons and UP arrow
Iconos que saltan y echa ARRIBA
Use ONLY the included AC Adapter to charge the battery.
Utilice SOLAMENTE el incluido CA Adaptor para cargar la batería.
PARAASISTENCIAYSERVICIO,CONTÁCTENOSEN
support.rcatablets.com
FORSUPPORTANDSERVICE,PLEASECONTACTUS
support.rcatablets.com
Swipe up to unlock the screen.
Deslizar hacia arriba para desbloquear la
pantalla.
Equipment tested for
compliance as a
complete unit
RCT6A03W13 RCT6A03W13
Equipo probado para
cumplimiento como una
unidad completa
DOCKING / ACOPLAMIENTO
UNDOCKING / DESACOPLAMIENTO
Microphone
Charging indicator
Reset
Rear camera
Power /
Standby
Headphones
Micro-USB
Connector
Volume
&
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
2.
Thisequipment complieswithRFradiationexposurelimitssetforthforanuncontrolledenvironment.
This equipment should be installed and operated with a minimum distance of 0cm bet ween the
radiator and your body.
FCC Declaración de Exposición de Radiación de RF:
1. Este transmisor no debe ubicarse ni funcionar conjuntamente con ninguna otra antena o transmisor.
2.
Esteequipocumpleconlos límitesde exposiciónderadiacióndeRFparaunambienteincontrolado.
Este equipo debe ser instalado y operado a una distancia mínima de 0cm entre el radiador y su cuerpo.
PRECAUCIÓN: Exposición a radiación de radiofrecuencia.
ParacumplirconlasexigenciasdeconformidaddeexposicióndeRF canadienses,estedispositivo ysu
antena no deben colocarse ni utilizarse conjuntamente con ninguna otra antena o transmisor.
ParacumplirconRSS102exigenciasdeconformidaddeexposicióndeRF,unadistanciadeseparacióndeal
menos
0cm
debe ser mantenida entre la antena de este dispositivo y todas las personas.
Laoperaciónenlafrecuencia5150-5250MHzessóloparaelusodeinteriorparareducirelpotencialpara
lainterferenciadañosaalco-canalsistemasdesatélitemóviles.
Para la frecuencia 5600-5650 MHz, no se permite ninguna operación.
CAN ICES-3(B) / NMB-3(B)
ThisdevicecomplieswithIndustryCanadaLicense-exempt RSSStandard(s). Operationis subjecttothefollowing
two conditions: (1) This device may not cause inter ference, and (2) this device must accept any interference,
including interference that may cause undesired operation
of the device.
Caution: Exposure to Radio Frequency Radiation.
TocomplywiththeCanadianRFexposurecompliancerequirements,this deviceanditsantennamust
not be co-located or operated in conjunction with any other antenna or transmitter.
TocomplywithRSS102 RFexposurecompliancerequirements, aseparationdistanceofatleast0cm
must be maintained between the antenna of this device and all persons.
Warning:theACadapterisusedasdisconnectdeviceanditshouldremainreadilyoperableduringintended
use. In order to disconnect the mains plug from mains completely, the AC adapter should be disconnected
from the mains socket outlet completely. The socket-outlet shall be installed near the equipment and shall be
easily accessible.
CAN ICES-3(B) / NMB-3(B)
EstedispositivocumpleconlasnormasRSSde IndustryCanada paradispositivos exentosde licencia.El
funcionamiento de este equipo está sujeto a las dos condiciones siguientes: (1) que este aparato no provoque
interferencia y (2) que este aparato pueda recibir cualquier tipo de interferencia, incluida la interferencia que
pudiera causar un funcionamiento indeseado del
equipo.
Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.