11
PROGRAMMING SLEEP FEATURE
1. Press and hold the SLEEP key
until the indicator light illuminates.
Release the SLEEP key.
2. Enter time in minutes using the
numerical key pad. The indicator
light should turn off. (Minute 1 thru
9: press 0 before the actual number.
Maximum: 99 minutes).
3. Leave remote aimed at television.
(Sleep Feature will not work unless
remote is left aimed at television).
CANCELING THE SLEEP TIMER
The Sleep Timer program will be
canceled and reset to zero by either
of the following.
1. Press and hold the SLEEP key
until the indicator light blinks.
2. Press the ON•OFF key, turning
the TV off.
This feature will automatically turn off your TV
at a duration you choose from 1 to 99 minutes.
Sleep Feature
INDICATOR
LIGHT
ON•OFF
(BLINK)
SLEEP
SLEEP
This remote cannot access every menu system of all models
and brands of consumer electronics components. However,
if you’ve successfully programmed the DVD•AUX key to
operate a DVD player, you can access DVD disc menus with
the MENU key.
The MENU key will also access TV menu systems for
most RCA, GE and PROSCAN TV's, as well as some other
popular brands. Also, some RCA VCR menus are supported
by this remote’s menu key. This remote also supports select
satellite receiver menus.
If this remote’s MENU key doesn’t access the menu system
for your component, you’ll need to use the original remote
to change menu settings.
Note: This remote’s MENU key doesn’t support cable box
menu systems and some VCR menu systems.
Using On-screen Menus
OR
5. The number that causes the indicator
light to blink is the first digit of
your code.
6. Repeat step 4 until you have retrieved
all three numbers of the code.
7. Refer to the code box to write down
the code for your component within
the Direct Entry Section (pages 5-8)
for the component just programmed.
(BLINK)
To Next Page
Loading...
Need help?
General
