5
(OFF)
ON•OFF
TV CODE
Program for TV—
Direct Entry Method
1. Manually turn on the TV.
2. Locate the enclosed TV Code List.
Find your brand of TV.
N
ote:
If your brand isn’t listed, use
one of the Code Search methods to
program this remote control (See
Code Search on page 8).
3. Press and hold the CODE SEARCH
key until the indicator light
illuminates. Then release the
CODE SEARCH key.
4. Press and release the TV key. The
indicator light blinks and then remains lit.
5. Use the number keys to enter
the first code listed for your brand.
After you enter a valid four-digit
code, the indicator light turns off.
Note: If you enter an invalid code,
the LED will flash rapidly for 2
seconds. Start over at step 3.
6. Aim the remote at your TV and press
the ON•OFF key. If your TV turns
off, you have found the correct code.
7. Enter the code in the box provided
on this page for future reference.
8. If your TV doesn’t turn off, repeat
steps 3-6 above, entering the next
code for your brand.
If none of the codes work or your
brand is not listed, use one of the
Code Search methods to program this
remote (See Code Search on page 8).
For a description of each key on the
remote control, refer to the Key
Descriptions section on page 3-4.
In order for the 3-component universal remote to control
your TV, you must program it with the TV code that matches
your TV. These instructions explain the preferred method of
programming the remote—the Direct Entry method.
C
ODE
S
EARCH
INDICATOR
LIGHT
(BLINK)
TV
To Next Page
Loading...
Need help?
General
