INITIAL SETUP
When you turn on your television set for
the first time, be sure to place it on a solid
stable surface.
To avoid danger, do not expose the TV
to water, or a heat source
(e.g. lamp, candle, radiator).
Do not obstruct the ventilation grid
at the rear and be sure to leave sufficient
gaps around the unit.
PUTTING THE UNIT ON A PROPER PLACE
TURNING THE UNIT ON FOR THE FIRST TIME
After you have initially connected your TV
antenna or cable,
turn the television ON.
A screen will display asking you to run a
to search and receive
available local digital channels.
It is here where you will select antenna options
and run .
Channels will be stored in the TV tuner.
Press the button on the remote control.
Press the ▼ button to highlight AIR/CABLE.
Channel Auto Scan
Channel Auto Scan
MENU
Using the ◄ ► buttons, scroll to highlight mode.TV
SOURCE SELECTION
1.Press the SOURCE button on the remote control.
2.
the ENTER button.
Note:
1. Before watching please make sure all necessary
cables and devices are connected.
Use or▼button to select the optionsthe▲
(The screen will change to your desired source
(TV,Component HDMI1,HDMI2,HDMI3 ,VGA)
/AV,
and select any of them using the ► buttonor).
12
2. When connecting the component or AV of DVD
devices, First select Component/AV, then the upper
right corner of the screen will display corresponding
Component or AV.
Please run
Channel Auto Scan
INPUT SOURCE
TV
HDMI1
VGA
YPbPr/AV
HDMI2
HDMI3
To Next Page
Loading...
Need help?
General
