Using the CD Player
EN
7
This section contains a set of step-by-step
procedures on how to use your new 5 DISC CD
CHANGER PLAYER. Press POWER to turn on the
unit, the display will show the “NO DISC”
message. Select your favourite CDs and start
loading!
Loading Discs
1. Press OPEN/CLOSE to slide out the CD
compartment tray automatically.
2. Load one to five discs onto the tray.
3. Press DISC SKIP to rotate the tray for
loading more CDs onto the other parts of the
tray.
4. When you’ve finished loading, press OPEN/
CLOSE to close the tray.
Track Number (flashes)
Disc Number (flashes)
10 11 12
13 14 15
REPEAT 1
DISC
1
2
34
5
Elapsed Time
Track Number
Playing Discs
Now you can select a disc by pressing one of the
DISC DIRECT ACCESS buttons or press DISC SKIP.
After you have made your selection, the unit
starts playing from track 1. The display shows a
flashing disc number, track number, elapsed time
of track play, a flashing track number, and a
flashing Direct Disc Access button indicating the
playing disc. (Also refer to Fig. 2)
Press STOP to end CD play mode.
Fig. 2
DISC SKIP DISC DIRECT ACCESS
PHONES PHONES LEVEL SHUFFLE INTRO ATS
CLEAR
REPEAT PROGRAM
POWER
STANDBY
MAXMIN
OPEN/CLOSE
PLAY/PAUSE
STOP
SIMULTANEOUS PLAY AND LOAD SYSTEM
DIGITAL OPTICAL OUTPUT
5 DISC CHANGER
DISC 1 DISC 2 DISC 3 DISC 4 DISC 5
RP8070 IB rev3 8/14/01, 4:59 PM8
To Next Page
Loading...
Need help?
General
