Remove & Close The Lens Cover
Placing of Your Projector
To Reduce Image Distoron
Your projector can be installed in four different configurations (see picture below):
5
Remove the lens cover before using Close the lens cover when unit not using
Front Table
Rear Table
Front Table:
Select this location with the projector placed near the floor
in front of the screen. This is the most common way to
position the projector for quick setup and portability.
Rear Table:
Select this location with the projector placed near the floor
behind the screen.
NOTE: That a special rear projection screen is required.
• Move the projector as close to the center
of the screen as possible.
• The light beam from the projector should
be perpendicular to the screen for a
rectangular or square image.
LENS COVER
REMOVE
CLOSE
LENS COVER
OK
PAIR
POWER
VOL
VOL
OK
PAIR
POWER
VOL
VOL
To Next Page
Loading...
Need help?
General
