Malfunction display and solutions
When the washer is in trouble, please contact local service office or the sales service
department of our company and the customer should not dismantle the machine
without permission.
If the washer can not work normally, and the abnormal indication is shown in the digital
display window or the machine alarms, please check and correct as follows.
18
Technical specifications
Water injection for about
16 minutes, but do not
reach preset water level
“E1” flares, and
other lights are
turned off.
After draining for 4
minutes, does not finish
draining.
Fault
Cause of fault
Indication
Alarm of the
buzzing sound
Stopping alarm
Alarm for
water inlet
Alarm for
opening lid
Imbalance
alarm
Drain alarm
“E2” flares, and
other lights are
turned off.
“E3” flares, and
other lights are
turned off.
“E4” flares, and
other lights are
turned off.
“E5” flares, and
All water lever
lights flash.
overflow alarm
Note: 1: alarm removed, the return to the status before the alarm; E3 failures appear in the same trip.
2: overflow alarm, automatic water drain valve open until the manual intervention contact failure.
515X525X938
31kg
3.0A
1.68Cu.ft
120
60
Current
value
Drum Size
Open the lid after starting
the delay time. Open the lid
when the washer is spinning.
Open the lid when entering
into the child lock state.
Water level is higher than
rated overflow level
Power off,
repair
1.6Cu.ft
To Next Page
Loading...
Need help?
General
