EN
Getting Started
Unpacking the system:
You should have the following:
• one main unit (with 2 main speakers);
• one remote control;
• one user’s guide;
• one safety leaflet.
• Owner and registration Card
Back View
1. FM Pigtail Antenna
2. Main Speaker Jacks
Using the Antenna
Before you use your audio system, you’ll want to
make sure the FM antenna is positioned properly.
Uncoil it, making sure it is fully extended (you may
even want to tape it to the wall behind the unit, if
possible. The higher, the better.)
For better AM reception, rotate the unit.
Connecting the Speakers
Each speaker has a black (negative) and a red
(positive) jack. When connecting the speakers, match
the red wires to the red jacks and the black wires to
the black jacks.
Installation
To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
4 inches
4 inches
Front View
4 inches
4 inches
2 inches
Side View
FM ANT
Release tab to lock wire in
the terminal.
NOTE: Make sure the insulation
is completely removed from the
ends of the
speaker wires at all connection
points.
Speaker
Wire Connection
Push terminal tab
down to
insert wire.
To Next Page
Loading...
Need help?
General
