8
1. Press SOURCE to select TUNER.
2. Press BAND to select between AM or FM radio
band.
Tuning to a Station
Press SKIP FORWARD/ BACKWARD to select fre-
quencies.
Using Presets
The tuner can be either
TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
Press SKIP BACKWARD or SKIP FORWARD on the
main system or PRESET UP or DOWN on the remote
control to access the previous or next preset station.
The display first shows the preset program number
and after a few seconds, the frequency and preset
program number will be displayed. (FMPR:01 is FM
preset 1)
Auto Preset
Programming
(for FM only)
Press and hold BAND
button for 2 second to scan stations in the selected
band. The stations will then be stored as preset chan-
nels. A Maximum 32 stations can be stored. Beware of
your preset channels being erased accidentally
because the scanning and storing process is automatic
upon pressing the button.
You can stop the automatic scan by pressing any but-
ton, but the erased stations cannot be recovered.
Setting Presets
1. Press SKIP FORWARD/ BACKWARD to access the
desired frequency.
2. Press the SET button once.
3. The most recently accessed program location will
be displayed.
4. If a different program location is preferred, press
SKIP BACKWARD / FORWARD to move to the
desired preset number (1-32).
5. Press SET to store the selected frequency at that
preset.
Suppressing Stereo Signal
Press FM ST to toggle between FM mono and stereo
for stereo FM stations. (Remote Only)
PR:01
87.50 MHz
To Next Page
Loading...
Need help?
General
