41
OTHER FEATURES
Go-To Search
The Go-To Search feature enables the VCR to quickly locate a
counter reading anywhere on the tape. When the VCR locates
the counter reading, it will begin playback.
1. Press STOP.
2. Press SEARCH on the remote until the GO-TO SEARCH menu
appears on the screen.
3. Press number buttons to enter the hour(s) and/or minutes of
the counter reading you want the VCR to “go to”. Press
CLEAR on the remote to correct an entry.
4. Press FWD to search forward or REV to search in reverse.
5. Press STOP to stop Go-T o searching.
Tracking
Your VCR has automatic tracking which removes the str eaks or
snow from the picture. Automatic tracking is activated when you
insert a tape or turn on the VCR. Occasionally you may need to
manually adjust tracking, especially if the tape was recorded on
a different VCR. Just use the TRACK buttons to r emove the
streaks or snow. You can also use tracking when you pause a
tape to reduce jittering of the picture.
When you manually adjust the picture, automatic tracking is
turned off. To turn automatic tracking back on, press both
TRACK buttons on the front of the VCR at the same time, or
eject the tape and re-insert it. Tracking has no effect during
recording – only playback.
Pro-Tect Plus
™
Locking Feature
To disable the usage of the VCR, or to protect your timer
recordings, you can lock the VCR so that the buttons on the
VCR or remote won’t work.
• To Lock: Press and hold the VCR button on the remote
for approximately six seconds.
• To Lock While a Timer Recording is in Progress: Press
and hold the VCR button on the remote for approximately
six seconds.
• To Unlock: Press and hold the VCR button on the r emote for
approximately six seconds.
Locking Your VCR:
If a timer recording is programmed,
make sure your VCR is turned off.
Locking your VCR prevents the VCR
from being accidentally turned on.
GO-TO SEARCH
Current tape counter is
2:17:25
Press REV or FWD
to go to 0:00:00
Press SEARCH to exit.
To Next Page
Loading...
Need help?
General
