l
’ *A
l
1) Turn on the audio source (TV or audio component) to which
the transmitter is connected:
2) Switch the ON/OFF switch on the headphone to ON.
3) Place the headphones- on your head and adjust the volume
control to the desired listening level. The adjustable head-
band lets you adjust the length of the headphones for a
comfortable fit.
4) Tune the frequency adjustment control, located on the back of
the transmitter, to a mid-level setting. Just rotate the thumb-
wheel knob up or down and leave it set approximately in the
middle of the range.
5) Adjust the tuning dial of the headphone to the frequency of
the transmitter for best reception.
l
You should now be able to walk freely from mom to room without disruption.
If
disruption should occur (signal breaks up), adjust the headphones tuning control
to maximize stereo reception.
If you hear interference horn other components, readjust the tuning control.
Move
the control on the transmitter to a different setting then adjust the control
on the headphones to match the new setting.
You
may have to try a few loca-
tions to find one with no interference.
When transmitting/receiving over long distances, the signal from the system will
become weaker and the stereo indicator light will go dim.
For protection of the transmitter and to save power, the transmitter will cut off
automatically in about one minute when the input signal from the audio source
is too weak for operation. If the signal is restored, the transmitter will work
again autoinatically.
7
To Next Page
Loading...
Need help?
General
