1514
ASSEMBLY AND USE
SECURING YOUR CHILD
Canopy Rotation
1. Pull or push the front of the
canopy to extend or retract.
Using the Boot
(Full Recline Only)
1. Lower the seat back to the
lowest position. Place the
boot at the front of the seat
inserting the two Velcro
straps through the loops
on the seat. Attach the two
straps up to secure to the
child’s tray.
2. Attach (4) straps around the
frame tubing and snap into
place.
NOTE: ALWAYS use the boot
when seat back is fully reclined.
Handle Adjustment
1. To adjust the handle position,
push both handle adjustment
buttons at the same time and
adjust to the desired position.
1. Adjust shoulder strap height
by unclipping the harness
clips and reattaching to one
of the three height positions.
The harness straps should
be located at the position just
above the child’s shoulders.
2. Release the harness by
pushing the gray button on
the buckle.
3. Place the child in the seat
and buckle the harness by
placing the inserts into the
slots of the buckle.
4. Tighten or loosen the harness
straps by sliding the harness
adjusters on the shoulder
straps and the hip straps.
1/2
Section 7: Securing Your Child
1
1
1
2
3
To Next Page
Loading...
Need help?
General
