Charge the GoBlock | 13
CHARGE THE GoBlock
GoBlock contains a high-quality lithium iron phosphate battery (LiFePO
4
) battery that is capable of a
rapid 50A recharge rate.
The GoBlock is supplied partially charged, however charging the battery fully before its first use is
recommended. This is in order to equalise the internal battery cells for optimum battery cycle-life,
and to ensure that the Battery Level LEDs are as accurate as possible.
The GoBlock does not need to be completely flat before charging and can be topped up
at any time.
CAUTION
When recharging the GoBlock internal battery at the full 50A rate, or when the total
input/output load current is ≈50A, the top housing around the inputs/outputs may become
hot — take care when handling.
When recharging the GoBlock internal battery, ensure that there is airflow around the unit
to prevent it from overheating — do not charge in direct sunlight/hot area as the charging
performance may be affected.
Only use the supplied AC Charger (Mains Trickle-Charger) to charge the GoBlock.
The GoBlock has the following charging options:
7.5A AC Mains Trickle-Charger (240VAC) (supplied)
7.5A DC Accessory Socket Trickle-Charger (supplied)
Up to 50A Anderson™ input from solar panels (solar panels sold separately)
50A Anderson™ input using vehicle power (Anderson™ cable required, sold separately)
50A DC vehicle power via the PowerDock (dock sold separately)
Up to 50A DC fixed solar panels via the PowerDock (dock and solar panels sold separately)
Charge From an AC Outlet
Plug the supplied 7.5A Mains Trickle-Charger into a powered AC outlet, then plug the charger into
the Trickle-Charge Input on the GoBlock.
Charging from an AC wall outlet.
CONTENTS
To Next Page
Loading...
Need help?
General
