Care and Maintenance | 29
CARE AND MAINTENANCE
Care and Maintenance Advice
Carefully inspect the unit before each trip to ensure it is in good condition. Do not use the
GoBlock if you suspect that it has been damaged in any way.
Always close the socket dust covers when input/output sockets are not in use.
Keep the protective covers closed whenever possible.
Do not subject connectors that are plugged in to excessive pulling or twisting. Excessive or
repeated forces on the sockets may damage them or result in loose electrical connections.
If sand, grit, or dirt accumulate on the body, handle extension rails, or in the compartments, wipe
them clean with a damp cloth. Do not rinse/hose with water.
Do not apply lubricants to the rails, as it could cause damage to the mechanism and body of the
unit.
Periodically check that the PowerDock Interface is clean and free of mud and grit before inserting
into the dock. Wipe with a clean damp cloth.
Do not use solvents to clean the GoBlock.
Do not allow the GoBlock to come into contact with corrosive substances.
Turn the Storage Isolation Switch to 'OFF' prior to prolonged periods of storage. See 'Storage
Isolation Switch' on page30 for more information.
Do not fully charge or discharge the GoBlock prior to prolonged periods of storage. See
'Long-Term Storage' on page30 for the recommended storage charge levels and detailed
maintenance advice.
In regular usage conditions, do not allow the GoBlock's charge level to remain below 10% for
extended periods of time. Charge the GoBlock as soon as possible.
CABLE STRAIN RELIEF
The 50A Anderson™ Output socket has an in-built cable strain relief that should be used to reduce
strain on the Anderson™ socket and connector. Wrap the fastening strip around the connector
body and secure tightly.
The Anderson™ output cable
strain relief.
CONTENTS
To Next Page
Loading...
Need help?
General
