Transporting the GoBlock | 27
Safe Vehicle Transportation
WARNING
An unsecured GoBlock can become dangerous in an accident or sudden stop. The GoBlock
must be adequately restrained for safe transportation in a vehicle. Choose appropriate load
restraint equipment, and ensure it’s in good working order before every use.
Load straps/restraint equipment must be replaced if they show any signs of wear or damage,
or if the vehicle is in a minor or major accident.
Do not leave sharp objects (e.g. drills, saws, knives, blades etc.) leaning on or nearby to the
tie-down straps.
The GoBlock must be installed behind (not in front) of the vehicle seats. Do not install the
GoBlock in the vehicle interior area shared by occupants.
Load straps and rings should each have a minimum 200kg (440lb) load capacity.
RECOMMENDED RESTRAINT METHODS
The following methods are recommended to restrain the GoBlock for safe transportation in a
vehicle, however it is the vehicle operators responsibility to ensure that the restraint method
and equipment comply with local laws and standards.
Dock the GoBlock in the PowerDock (sold separately — refer to installation instructions supplied
with the PowerDock to ensure the dock is correctly installed/anchored), and for instruction on
how to dock the GoBlock.
Restrain the GoBlock using tie-down straps attached to vehicle-mounted anchor points. Each
strap and anchor point must be individually rated to a minimum of 200kg (440lb). See 'Restrain
the GoBlock using Tie-Down Straps' (page28) for further information.
CONTENTS
To Next Page
Loading...
Need help?
General
