E2/E2 Lite Notes on Usage
R20UT4582EJ0100 Rev.1.00 Page 20 of 30
Jul.16.19
3.3 Notes on Using the Emulator Debugger
This section describes how to set the [Debug Configurations] window of the e
2
studio. To open the [Debug
Configurations] window, click on [Run] → [Debug Configurations…] or the downward-pointing arrow next to
the icon→ [Debug Configurations…].
Figure 3.2 Opening the [Debug Configurations] Window
Figure 3.3 [Debug Configurations] Window
3.3.1 Notes on Connecting the Emulator Debugger
(1) Reset state
Under [Connection] on the [Connection Settings] tabbed page, be sure to select [Yes] for [Hold reset
during connect] (the operation is explained for the case when the e
2
studio is in use).
When [Yes] is selected, during connection to the emulator debugger, the emulator maintains the low-level
output on the RES# pin of the MCU and places the MCU in the OCD mode. However, to start the
operation of the built-in debugging circuits of the MCU, the emulator releases the reset for about 50 msec
while it is connected, and the user program automatically runs during that period.
To Next Page
Loading...
Need help?
General
