Revamp LIBERATE CORDLESS User Manual

• The temperature indicator LED will flash until the hot brush is ready to use. When the
hot brush is ready to use, the LED will remain static.
• Working on one section at a time run the straightener through the entire length of
the hair from roots to ends, without stopping. Use a comb while straightening for even
straighter results.
• Repeat this process all over the head, allowing hair to cool before combing through.
• Aer using the straightener, switch off, unplug, place on heat resistant suace and
allow to cool before storing away
• For extra safety and ease of storing, lock the plates together and place the device in
the heat resistant travel pouch as shown in the Features section. Let the straightener
cool down before placing it into the heat resistant travel pouch.
Follow us on www.revamphair.com.au for the latest hair tips and advice.
Please note:
• Repeat only twice per section to prevent hair damage.
• This is a high-peormance product, avoid frequent use to prevent hair damage.
• Regular use of styling products may deteriorate the suace coating over time.
• Do not scratch the suace of the product as this will deteriorate the effectiveness of
the coating.
• Burn hazard. Keep appliance out of reach from young children, paicularly during use
and cool down
• While heating, during use and cooling, place on heat resistant suace or on top of the
REVAMP heat-resistant travel pouch. Only hold unit by the handle.
• The product reaches a very high temperature during operation, please style with
caution when using. Make sure to keep away from the scalp and skin to avoid burns.
• Always place the appliance with the stand, if any, on a heat-resistant, stable flat suace
CHARGING YOUR LIBERATE CORDLESS STRAIGHTENER
You must recharge your Liberate Cordless straightener when it runs out of charge by using
the adaptor provide in the box with the straightener. The charging time should be of 3
hours from empty for approximately 30 minutes use according to the temperature seing
selected.
Whilst charging, the blue LED light of your straightener, indicating the baery level of the
device, will flash slowly and continuously. There are 4 blue LED lights on your straightener
that indicates the level of baery charged.
1st LED light from 0% to 25%
2nd LED light from 25% to 50%
3rd LED light from 50% to 75%
4th LED light from 75% to 100%
Once the blue LED light becomes static, this means the baery is charged to the level
indicated above.
Please note:
Warning: If the white temperature LED lights are all flashing at the same time on and off,
then the appliance is faulty. If this happens, please stop charging and remove the adaptor
from the mains and contact our Customer Care Centre for fuher advice.
CLEANING & MAINTENANCE
• Switch the appliance off, unplug from the mains and allow to cool fully before cleaning.
• Wipe over all suaces using a so damp cloth. Do not use harsh abrasives or cleaners.
• Do not immerse the appliance in water or and other liquid.
• Ensure all pas are dried thoroughly with a so towel before reusing.
• To prevent any damage to the charging cable, do not wrap the cable around the
appliance, always store the cord loosely next to the appliance.
• Store in a cool dry place.

Revamp LIBERATE CORDLESS Specifications

General

Brand	Revamp
Model	LIBERATE CORDLESS
Category	Styling Iron
Language	English