Rheem Classic
®
Series Two-Stage
Upflow/Horizontal Gas Furnaces
FORM NO. G11-514 REV. 1
RGPQ- Series
80% A.F.U.E.†
Models with Input Rates from
45-105 kBTU
(U.S. & Canadian Models)
✝A.F.U.E. (Annual Fuel Utilization Efficiency) calculated in accordance with
Department of Energy test procedures.
• The Rheem Classic
®
Series 2-Stage line of upflow/horizontal
gas furnaces are designed for utility rooms, closets, alcoves,
or attics. Because of the low-profile 34 inch [864 mm]
height, the upflow model can also be used to satisfy most
applications that traditionally call for a horizontal furnace.
• The design is certified by CSA International.
• Patented heat exchanger, constructed of aluminized steel for the
maximum in corrosion resistance and thermal fatigue reliability.
• Low profile “34 inch” design is lighter and easier to handle,
and leaves room for optional equipment.
• Convertible from upflow to horizontal left or right without field
conversion.
• Left or right side gas and electric inlet connections with quick,
simple change.
• Direct spark ignition models equipped with remote sense and
feature an integrated board with humidifier and electronic air
cleaner hookups.
• Insulated blower compartment, a two stage gas valve and a
specially designed two speed draft inducer motor make it one
of the quietest furnaces on the market today.
• Pre-paint galvanized steel cabinet.
• Molded permanent filter.
• Grab-holes in doors to aid in easy door removal and
replacement.
• Compatible with single or two-stage thermostat. (For optimal
performance two-stage thermostat recommended.)
• A variety of cooling coils and plenums designed to use with
Rheem Classic
®
Series 2-Stage gas furnaces are available as
optional accessories.
• Furnaces can be installed in an upflow position or laid on
either side in a horizontal position. Field conversion not
required.
Air
Gas Furnaces
RGPQ Series
To Next Page
Need help?
General