Description
Water Heater
Disabled
The water heater is disabled and not in any active mode.
Standby
The water heater is in a non-active mode where the temperature of the water
in the tank is within the set point limits.
Pre- Purge
17 seconds
initial step in a heating cycle wherein the blower is energized to clear any
potential by products of combustion from the heat exchanger.
Ignition
The ignition system and gas valve are energized during this period. Igniter
should be sparking and gas valve should be releasing fuel.
Heating
This message appears when a call for heat is present and the burner is actively
firing.
Post Purge
When the call for heat is satisfied, the gas valve is de-energized while the
blower remains energized to clear the heat exchanger.
Retry Test failed ignition and it is retrying
Recycle The water heater is in the 30 minute delay between retries
Fault The water heater is experiencing a malfunction and displaying an error code
Ign. Control
Error
The display is not communicating with the ignition control
18
Triton Service Manual SVC1020T ; Rev 4
80 and 100 gallon chassis
Display Messages on Control Board
To Next Page
Loading...
Need help?
General
