15
5. Other Information for This Machine
Laser Safety
This machine complies with the requirements of IEC60825-1:2014 (EN60825-
1:2014) for class 1 laser product. The machine contains four 4ch-Laser Diode
Arrays (4ch-LDA). Laser diodes are AlGaInP, 657–663 nanometer wavelength
for each emitter. The beam divergence angle is 16 degrees (minimum) and 25
degrees (maximum) in the vertical direction, and 7 degrees (minimum) and 13
degrees (maximum) in the horizontal direction, and laser beams are generated
in Continuous Wave (CW) mode. Each 4ch-LDA has four light sources and the
maximum output power of the light source is 17 milliwatt.
The following label is attached on the rear side of the machine:
Caution
Use of controls or adjustments or performance of procedures other than those
specified in this manual might result in hazardous radiation exposure.
Notice to Users in EEA Countries
Declaration of Conformity
Notice to Users in EEA Countries
This product complies with the essential requirements and provisions of Directive 1999/5/
EC of the European Parliament and of the Council of 9 March 1999 on radio equipment and
telecommunications terminal equipment and the mutual recognition of their conformity.
The CE Declaration of Conformity is available by accessing the URL:
http://www.ricoh.co.jp/fax/ce_doc/ and selecting the product applicable.
For Users in India
This product complies with the “India E-waste Rule 2011” and prohibits use of lead,
mercury, hexavalent chromium, polybrominated biphenyls or polybrominated
diphenyl ethers in concentrations exceeding 0.1 weight % and 0.01 weight % for
cadmium, except for the exemptions set in Schedule 2 of the Rule.
To Next Page
Loading...
Need help?
General