Why does the lamp burn out or make a popping sound in my Ricoh PJ WX5461?
When the lamp in your Ricoh Projector reaches its end of life, it will burn out and may make a loud popping sound. If this occurs, the projector will not turn on until you replace the lamp module. To replace the lamp, follow the procedures in the 'Replacing the Lamp'.
How to fix Ricoh Projector when no image appears on screen?
If no image appears on the screen when using your Ricoh Projector, first ensure all cables and power connections are correctly and securely connected. Also, check that the pins of the terminals are not crooked or broken. Verify the projection lamp is securely installed. Ensure you have removed the lens cap and that the projector is switched on. Finally, make sure the 'AV Mute' feature is not activated.
Why is the image too small or too large on my Ricoh PJ WX5461 Projector and how to fix it?
If the image from your Ricoh Projector is too small or too large, you can adjust it by using the Zoom lever on the top of the projector. Alternatively, try moving the projector closer to or further from the screen. You can also press the 'Aspect' button on the remote control, or navigate to 'SCREEN > Aspect Ratio' in the menu to explore different settings.
General| Resolution | 1280 x 800 (WXGA) |
|---|---|
| Contrast Ratio | 20, 000:1 |
| Weight | 3.0 kg |
| Display Technology | DLP |
| Projection Size | 30 to 300 inches |
| Lamp Life | 4000 hours |
| Connectivity | HDMI, USB, LAN |
| Input Ports | HDMI |
To Next Page
