Rigol DS6104 Quick Guide

RIGOL
DS6000 Quick Guide
5
Figure 6 To Install the Battery
Power-on Inspection
When the oscilloscope is energized, press the power key at the lower-left corner
of the front panel to turn on the oscilloscope. During the start-up process, the
oscilloscope performs a series of self-tests and you can hear the sound of relay
switching. After the self-test, the start-up image is displayed. Press UTIL  System
 SelfCalInfo to view the self-test results.
To Connect the Probe
RIGOL provides passive and active probes for the DS6000 series oscilloscopes. For
detailed technical information of the probes, please refer to corresponding Probe
User’s Guide. The following are the probes recommended for use with this
oscilloscope.
Model
Description
RP5600
600 MHz, passive probe, standard, auto detection
RP3500
500 MHz, passive probe, optional, auto detection
RP6150
1.5 GHz, passive probe, DS610X standard, auto detection
RP7150
1.5 GHz, active probe, optional, auto detection
Connect the Probe:
1. Connect the BNC terminal of the probe to a channel BNC connector of the
oscilloscope at the front panel.
2. Connect the probe tip to the circuit point under test and connect the ground
alligator clip of the probe to the circuit ground terminal.

Rigol DS6104 Specifications

General

Brand	Rigol
Model	DS6104
Category	Test Equipment
Language	English