Rigol MSO7000 Series Quick Guide

RIGOL
MSO2000A/DS2000A Quick Guide
4
Turn-on Checkout
When the oscilloscope is connected to power, press the Power key at the
lower-left corner of the front panel to start the oscilloscope. During the start-up
process, the oscilloscope performs a series of self-test items and you can hear the
sound of relay switching. After the self-test, the welcome screen is displayed. The
instrument is installed with the trial versions of the options before leaving factory and
the remaining time is about 2,000 minutes. The "Current Options"dialog box will be
displayed if your instrument has currently installedthe trial versions of options. From
this dialog box you can view the types, names, versions and the remaining time of
the options currently installed.
To Connect the Probe
RIGOLprovides passive probes for DS2000A, and provides passive probes and logic
probes for MSO2000A. For the model of the probes, please refer to
MSO2000A&DS2000A Series Datasheet . For detailed technical information of the
probes, please refer to corresponding Probe User’s Guide.
Connect the Passive Probe:
1. Connect the BNC terminal of the probe to an analog channel inputof the
oscilloscope onthe front panel.
2. Connect the ground alligator clip or spring of the probeto the circuit ground
terminal and then connect the probe tip to the circuit point under test.
Figure 5 To Connect the Passive Probe

Rigol MSO7000 Series Specifications

General

Brand	Rigol
Model	MSO7000 Series
Category	Test Equipment
Language	English