Linear operation guide: 13562-B 02-19 | 23
To remove the glass:
1. Using a screwdriver, loosen the three screws holding the louvre in place, remove the louvre,
and then remove the screws (so the glass can come out)—put the louvre to one side.
2. Push the top glass retainer latches up and slightly to one side to
release the top section of the glass.
3. Using the frame tabs at the top of the glass frame, lift up and gently
slide to the right and rotate the glass until the left section comes free,
then move the glass panel to the left to remove the right section.
4. Clean the glass, using a soft microbre cloth, and reinstall by following the above steps in
reverse order.
Ensure the glass is on correctly before turning the Linear back on. NEVER operate the
Linear without the glass in place.
DO NOT touch or adjust the burn media. Adjustment can only be done by a licensed
gasfitter as burn media positioning is critical to the safe operation of the fire
WARNING
To Next Page
Loading...
Need help?
General
