Risco ProSYS KP User Manual

3
Touchscreen Keypad
EN
Introduction
RISCO Group's Touchscreen Keypad is a slim and contemporary designed 7" touchscreen keypad
for the ProSYS Security System. The Touchscreen Keypad is compatible with any ProSYS version
and is available with or without a proximity reader. The Touchscreen Keypad enables to control
your security system as well as program its features.
For detailed information on programming the system refer to the ProSYS Installer and User manuals.
Installation
For the ProSYS Touchscreen installation procedure, refer to page 2.
Indicators
Power
On
System is operating properly from AC power and backup
battery is in good condition
Off No power
Slow Flash System is programming
Rapid Flash System trouble (fault)
Arm (Set)
On System is armed (set) in Full Arm or Stay Arm mode
Off System is disarmed (unset)
Slow Flash System is in Exit Delay
Rapid Flash Alarm condition
Stay/
Bypass
(Part Set/
Omit)
On
System is in Stay Arm (Part Set) or Zone Bypass (omit)
mode
Note:
The icon is equivalent to the icon on other ProSYS
keypads.
Off No bypass zones in system
Ready
On System is ready to be armed (set)
Off System is not ready to be armed (set)
Slow Flash
System is ready to be armed (set) while exit/entry zone
remains open
Fire
On Fire alarm in progress
Off Normal operation
Flashing Fire circuit problem
Tamper
On Zone/keypad/external module has been tampered
Off All zones are operating normally
Proximity
Flashing Indicates that the keypad has a proximity reader

Risco ProSYS KP Specifications

General

Brand	Risco
Model	ProSYS KP
Category	Keypad
Language	English