To Next Page

To Previous Page

Instructions for use

Charging

Auto: After cleaning, the robot will automatically return to the

charging dock to recharge.

Manual: In Pause mode, press the

button to send the robot

back to the charging dock.

The power indicator will ash slowly as the robot charges.

Note:

If the cleaning cycle was started away from the charging dock and the robot could not

return to the dock after cleaning, it will instead return to its starting point. Place the

robot directly on the dock to recharge it.

Error

If an error occurs while the robot is cleaning, the power indicator

will ash red quickly, and you will hear a voice alert. See

"Troubleshooting" for resolution options.

Note:

•

The robot will go to sleep automatically if left in an Error state for over 10-minutes.

•

Placing the robot on the charging dock in an error state will stop the current

cleanup.

Reset WiFi

If your phone cannot connect to the robot because you have

changed your router conguration, forgotten your password,

or any other reason, open the top cover to see the WiFi indicator

light, then press and hold the Spot Cleaning button and the

Recharge button until you hear the "Resetting WiFi" voice alert.

When the WiFi indicator light ashes slowly, the robot has entered

network conguration mode.

Spot Cleaning

In Standby or Pause mode, press and hold the button to start

spot cleaning. This mode is used to clean a 1.5m x 1.5m square

area centered on the robot. After cleanup, the robot will return to

the center of the square.

Note:

If the robot is left connecting to the network for over an hour, its WiFi will be disabled.

Reset WiFi before attempting reconnection.

Note:

Starting spot cleaning in pause mode will stop the current cleaning cycle.

1.5m

Roborock S4 Max User Manual

Questions and Answers: