_____________________________________________________________________________________________
© Rocket Milano s.r.l. - RE DOPPIA series. User Manual Ed. 01.2019. Specifications subject to change without notice. Page 7
INSTALLATION
This espresso machine is to be installed with adequate backflow protection
to comply with applicable federal, state, and local codes.
All machines are designed to ensure maximum possible user safety. It is, however, an
important responsibility of the user to observe the following safety codes to further
enhance safe installation and operation.
1. Always ensure that hazardous packing items such as plastic bags, Styrofoam,
nails, etc. are properly disposed of to prevent accidental injury to children or
other persons.
2. If there is evidence of defect or damage to the machine an authorised Rocket
Espresso Ltd. dealer or technician should be notified immediately so that
remedial action can be taken.
3. This machine is safe only when it has been correctly connected to an efficient
earthing/grounding system. This should conform to local safety standards and
legislation in force at the time of installation.
4. Installation of any Rocket Espresso Ltd. product should only be undertaken by
duly authorised, properly trained and qualified personnel
5. Protect the user by fitting a circuit breaker to electric supply feeding the
machine.
6. A residual current device (RCD) having a rated residual operating current not
exceeding 30mA must be installed.
7. The machines with electrical input over 16 A, must be connected to a net with
impedance = or < than 0,37 Ω.
8. Dangerous or improper electrical connections are extremely hazardous and
should never occur.
9. Always check the integrity of the component content of the machine. Never fit
defective or damaged spare parts. Always request replacement spare parts from
Rocket Espresso Ltd.
10. Before connecting the machine to electric supply, always check that capacity and
power rating at least equals the power requirement of the machine.
11. The machine must operate with clean soft drinking water. Never attempt to run
the machine with water that is harder than 7°F. The manufacturer recommends
use of an in-line filter.
12. Check the efficiency of the machine’s water drain. Drain tray is located under the
drip tray
13. This equipment must be installed on a flat, level and stable surface. The
minimum height of this surface is 1025 mm
14. Handle the machine with care.
To Next Page
Loading...
Need help?
General
