7
Português Italiano DeutschNederlands Español Français
English
Applying an e ect
Chorus
1. Set each channel’s [CHORUS] switch to the WIDE or SPACE
position.
WIDE
This is a stereo chorus that processes the three bands
independently.
By applying band-appropriate chorusing to each of the low,
mid, and high-frequency bands, this e ect creates a deep and
spacious chorusing that is appropriate for the sound of an
acoustic guitar.
The low range remains rmly localized in the center, and the
sound will become more spacious as you go from the mid to the
high range.
SPACE
This is a chorus that mixes the sounds in the air, a method that
is possible only with a stereo system. On the AC-33, the e ect
sound is emitted by the right speaker (as you face the unit), and
the direct sound is emitted by the left speaker. The chorus e ect
is produced as the sound from the left and right speakers is
mixed in the air.
Compared to an electrically mixed chorus e ect, this e ect
has a broader left/right spread and a more natural-sounding
spaciousness.
OFF No chorus e ect will be applied.
Turn the switch o if you don’t want to apply chorus.
Reverb/Ambience
1. Use the [REVERB/AMBIENCE] knob to adjust the amount of
e ect.
REVERB
This is a stereo reverb that was developed speci cally for
acoustic instruments and produces a spacious and natural
sound. The position of the knob adjusts the volume of the
reverb.
AMBIENCE
This e ect adds spatial depth. It produces a broader sound
eld and a sense of presence.
The position of the knob adjusts the volume and depth of the
ambience.
REVERB AMBIENCE
The left half of the knob’s range applies reverb, and the right half
applies ambience.
Turning the knob toward the right will deepen the e ect.
If you want to turn reverb/ambience o , turn the knob all the way to
the left.
About foot switches
If you use a foot switch (BOSS FS-5U or FS-6; sold separately) you’ll be able to turn chorus on/o and reverb/ambience on/o with your foot.
If a foot switch is connected, the pedal(s) will operate as follows.
Refer to p. 9 for details on the foot switch’s polarity setting.
If you use a phone plug (mono) cable to connect only one foot switch,
it will only turn chorus on/o .
Chorus on/o operations apply in common to the GUITAR CHANNEL
and the MIC/LINE CHANNEL.
If the CHORUS switch is o , operating the foot switch will not turn the
e ect on/o .
PCS-31
White
(TIP)
Red
(RING)
BOSS FS-5U
CHORUS
on/o
CHORUS
on/o
REVERB/AMBIENCE
on/o
REVERB/AMBIENCE
on/o
PCS-33
BOSS FS-6
To Next Page
Loading...
Need help?
General
