54
5-2 About Special Materials
This section describes some tips and important notes when using special materials with this unit. Note, however, that depending on
various factors or the usage environment, the use of some materials with this unit may not be possible. Before actual use, carry out
test feed and a cutting test to make sure the material is suitable for use with this unit.
[About the Separating Knife]
It may not be possible to sever some thicker materials (such as rubber sandblasting templates) or thin, flimsy materials.
Material with a strong tendency to reroll (that is, with a warp in the direction of the cutting surface) may catch on the carriage after
being cut off. Do not sever those materials with the separating knife.
[Rubber materials for sandblasting stencils]
It is important to note that the weight of the material may make motor errors more likely to occur.
If material feed is not smooth, creating an area of only carrier paper about 15 millimeters wide at both flanks of the material and
positioning the pinch rollers above these strips of carrier paper can make material feed more stable.
[Material with sprocket-feed holes]
Material for sprocket-feed use has feed holes along both
edges.
If the material is loaded with these holes lying over the pinch
rollers, material feed cannot be performed correctly.
When you are using this with this machine, load it as shown in
the figure.
To Next Page
Loading...
Need help?
General
