31
Convenient Functions
Deutsch Français Italiano PortuguêsEspañol NederlandsEnglish
Adjusting the Guitar and Mic Input Sensitivity
Turning O the Internal Speakers
Calling Up the E ect Stored in a Song (Patch Sync)
You can output audio from the JS-8's OUTPUT jacks to an external playback device (Ex. component stereo system).
When doing so, you may want to turn off the JS-8's internal speakers.
Use the following procedure to switch off the internal speakers.
The effect patch stored in each song can be called up at the same time that you switch songs.
You can connect a mic to the JS-8's GUITAR/MIC IN jack and adjust the input sensitivity.
1. Press [MENU].
2. Select SYSTEM, and then press [ENTER].
3. Select SYSTEM SETTING, and then press [ENTER].
4. Set SPEAKER SW parameter to OFF.
1. Turn the dial to select the desired song.
2. Press [MENU].
3. Select SONG INFO, then press [ENTER]
.
4. Press the right cursor button once to access the following
screen.
Effect Patch Number
OFF Play using the current effect patch.
P*** Call up the specified preset effect patch.
U*** Call up the specified user effect patch.
You can disable (turn off) the Patch Sync function in System
Settings (p. 39).
If this is disabled, the Patch Sync setting will be ignored, and
the currently selected effect patch will be used. (The effect
patch will not change when you switch songs.)
The Patch Sync function cannot be used for songs in USB
memory.
1. Press [MENU].
2. Select SYSTEM, and then press [ENTER].
3. Select SYSTEM SETTING, and then press [ENTER].
4. Set INPUT GAIN parameter to MIC.
• The JS-8 features an e ect especially designed for use
with mics. To choose this e ect, select MIC from the e ect
categories.
• When connecting a guitar to the GUITAR/MIC IN jack, set
the INPUT GAIN parameter back to GUITAR.
• Use INPUT SENS to precisely adjust the input sensitivity.
• The JS-8 does not feature a phantom power supply, so no
sound will be produced if you connect a condenser mic or
other mic that requires phantom power.
Specifies the
effect patch that
will be called up if
SOLO is ON.
Specifies the
effect patch that
will be called up if
SOLO is OFF.
If you press [MENU]
to select SET PATCH, the
currently selected effect
patch number will be
registered (assigned) to
PATCH SYNC.
To Next Page
Loading...
Need help?
General
