Deutsch Français Italiano Español Português NederlandsEnglishEnglish
Turning the Power On/O
Once everything is properly connected (p. 9), be sure to follow the
procedure below to turn on their power. If you turn on equipment in
the wrong order, you risk causing malfunction or equipment failure.
Turning the Power On
1. Turn the [L] switch ON.
After a brief interval, you’ll be able to produce sounds by playing the
keyboard.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after turning the unit on is required before it will
operate normally.
2. Use the Volume buttons to adjust the volume.
The volume increases when you press the Volume [+] button, and
decreases when you press the Volume [-] button.
This will adjust the volume of the speakers if you’re using the speakers
of the unit, or the volume of the headphones if headphones are
connected. Each volume setting (for speaker or headphone) is saved
automatically.
MEMO
The unit is designed so that nuances in the dynamics of your playing
will be clearly heard even at low volume, and that the sound will
remain clear even at high volume.
Turning the Power O
1. Turn the [L] switch OFF.
Setting the Reference Pitch
When playing ensemble with other instruments and in other such
instances, you can match the standard pitch to another instrument
(Master Tuning).
1. In “Various Settings (Function Mode)” (p. 12), choose “
F07
” and
then press the [s] button.
2. Use the [-] [+] buttons to set the reference pitch.
Examples:
Reference pitch Display
440.0 Hz (default)
40.0
442.0 Hz
42.0
Press the [s] button to return to the previous screen.
3. If you want to save the setting, carry out the Memory Backup
procedure (p. 12).
4. Hold down the [Metronome] button and press the [Split]
button to exit Function mode.
11
To Next Page
Need help?
General
