90
Appendices
Troubleshooting Other Problems
Parameters specified with pedal
assign can’t be controlled
❍
Could the effect be switched off?
→
To control a parameter using the expression pedal or
CTL pedal, make sure the effect that contains the
parameter you intend to control is switched on.
❍
Is something other than “Assignable” selected for the
Sub CTL 1,2 Function or Sub EXP Pedal Function
setting?
→
When operating a controller connected to the SUB EXP
PEDAL/SUB CTL 1, 2 jack, set the Sub CTL 1, 2 Function
(p. 55) or Sub EXP Pedal Function (p. 56) to
“Assignable.”
❍
Do the MIDI channel settings of both devices match?
→
Make sure that the MIDI channels of both devices match
(p. 80).
❍
Do the controller number settings of both devices match?
→
Make sure that the controller number of both devices
match (p. 60).
MIDI messages are not transmitted/
received
❍
Are the MIDI cables broken?
→
Try another set of MIDI cables.
❍
Is the GT-8 correctly connected to the other MIDI device?
→
Check connections with the other MIDI device.
❍
Do the MIDI channel settings of both devices match?
→
Make sure that the MIDI channels of both devices match
(p. 80).
❍
When you send messages from the GT-8, make sure the
GT-8 is set to the settings appropriate for sending data.
→
Check the on/off status (p. 80) for transmission of
program change messages and the settings for the
controller numbers to be transmitted (p. 81) .
Restoring the Factory
Settings (Factory Reset)
Restoring the GT-8 to the settings made at the factory is
referred to as “Factory Reset.”
Not only can you return all of the settings to the values in
effect when the GT-8 was shipped from the factory, you can
also specify the range of settings to be reset.
fig.09-060
1.
Turn off the power.
2.
While holding down PREAMP/SPEAKER On/Off
button and [TYPE VARIATION], turn on the power.
The Factory Reset range setting screen appears in the
display.
fig.09-070d
* To cancel Factory Reset, press [EXIT].
3.
Press PARAMETER [ ] [ ] to move the cursor,
and rotate the PATCH/VALUE dial to specify the range
of settings you want to restore to factory settings.
4.
If you want to proceed with the factory reset, press
[ENTER].
The specified range of data will be returned, and return
to the Play screen.
value
Explanation
System
System parameters, Harmonist scales, Auto Riff phrases, and
Preamp/Speaker, Overdrive/Distortion, and Wah Custom Edit
parameter settings
Quick
Content of the Settings Made with User Quick Setting
#1-1–#35-4
Settings for Patch Number 1-1 through 35-4
4
3123
The range of data you wish to factory reset
GT-8_e.book 90 ページ ２００７年６月２９日 金曜日 午後３時５５分
To Next Page
Loading...
Need help?
General
