Roland HP 1500 - Assembling the KS-1500 Stand; Checking Parts; Assembly Procedure; Adjusting the Adjusting Bolt

bh
Assembling the KS-1500 Stand for the HP-1500
Two people are needed to carry out the assembly. Never attempt it alone.
*
To move the main unit, be sure to keep it level while you lift it straight up. Be very careful, so
as to avoid getting fingers pinched, or toes hurt by accidentally dropping the unit.
EE Check the parts
Before
you
begin
assembly,
check
that
you
have
all
the
parts.
Side
board
(elt)
Side
board
(right
Pedal
board"
anter
büzerek
mk
1
Long screws (M6 x 60 mm) `
Short screws (M4 x 27 mm) `
Knob bolls
o Plus screwdriver ha
$i Cable clamps cscs 2 x
lll Assembly procedure
sy Extend the pedal cable out from the pedal board.
(Note) Bo sure that the side boards. are oriented
correctly: the metal fittings ure on the inside.
The metal fittings on the inside.
Pedal cable ..
«İs Use the long screws
(M6 x 60 mm) to lasten the
side boards lo the pedal
board
use two screws for each )
( side.
12; Use the short screws (M4 x 27 mm)
to attach the center board to the
side boards
( use two screws for each side. )
EN Attach the piano to the stand.
(Note) When placing the piano on the stand, be careful not to pinch your fingers.
(Avoid holding the ends of the pianu.)
iĝ) Align the screws (one on each side) located
on the bottom of the piano with the slots ..
in the metal fittings on the side UC
boards. Slide the piano so
the screws slide into the.”
slots. A
Lift up the piano and use the two
knob bolts to fasten the piano to
the stand
One screw each side on the left
1 and right.
7>
ra
Fasten the pedal cable with the cable clamps, and plug
in the power cable and pedal cable.
Cable clamps — —-- -
5) Alfix the cable clamps on the back left side of the sland
Fasten the pedal cable with the cable clamps
16) Insert the pedal cable into the pedal jack on the back panel
of the piano
7; Connect the power cabie into the AC inlet on the back
panel of the piano.
The power cable is included with the piano.
EN Adjust the adjusting bolt
3: When you finish assembling the stand, rotate the adjusting bolt until it
fouches the floor
(Note) If the piana is placed on carpeting, rotate the adjustment bolt little more.
(Note) When placing the piano in its location, be careful not tu pinch the power cable
underneath the piana.
:8: Rotate the adjusting bolt
until it touches the floor.