Roland Jazz Chorus JC-55 User Manual

PANEL ILLUSTRATION
@Control
Panel
(The
picture
shown
below
is
the
JC-77’s.
The
JC-55
does
not
feature
the
Hi-treble
Knob.)
Distortion Knob Hij-treble Control Middle Control Reverb Knob Chorus Depth Knob
Input Jacks Volume Knob | Treble Control Bass Control {Chorus Rate Knob] Chorus Selector Switch
@ Rear Panel
oom LINE OUT eon
EFFECT NORMAL
"
Reverb Foot
Switch Jack Line Out Jacks
Fuse der ‘ ‘
use Holder Chorus Foot | Distortion Foot
Switch Jack | Switch Jack
MIXED)
CONNECTION *Use the Line Out jacks to stack other guitar amplifier, or to connect a PA mixer or
recording equipment.
Normally, only one MONO(MIXED) Jack is to be used, but both of jacks may be
simultaneously used for benefitting maximum chorus effects. (If the Chorus Switch
is set to the OFF position, exactly the same signals are sent from these two jacks.)
*1f using a keyboard, connect it to the Low Input Jack.
Line In
Foot Switch Foot Switch
(FS-1) (FS-2)
To Hi Input
To Low Input
Keyboard
Guitar

Roland Jazz Chorus JC-55 Specifications

General

Brand	Roland
Model	Jazz Chorus JC-55
Category	Musical Instrument Amplifier
Language	English