91
Settings common to all modes (System Function)
System Function
Tx Edit Data (Transmit Edit Data Switch)
Specify whether changes you make in the settings of a patch or
performance will be transmitted as system exclusive messages (ON),
or will not be transmitted (OFF).
VALUE:
OFF, ON
Tx Active Sens (Transmit Active Sensing
Switch)
Specifies whether Active Sensing messages will be transmitted (ON)
or not (OFF).
VALUE:
OFF, ON
Device ID (Device ID Number)
When you want to transmit or receive System Exclusive messages,
set this parameter to match the Device ID number of the other MIDI
device.
VALUE:
17–32
Soft Thru (Soft Through Switch)
The Thru function re-transmits all messages received at the MIDI IN
connector to the MIDI OUT connector without modifying them in
any way.
VALUE:
OFF, ON
Making scale tune settings for a
patch (PATCH SCALE)
The Patch Scale function lets you use a variety of tunings for patches
used in Patch mode.
If you want to make scale tune settings for each part in
Performance mode, refer to
“Editing the scale tune settings
(SCALE TUNE)”
(p. 58).
Type (Patch Scale Tune Type)
You can switch the “Type” parameter to recall various sample
settings for Patch Scale. When you change “Type,” all patch scale
tune parameters will be changed automatically.
VALUE:
EQUAL, JUST (maj) in C, JUST (min) in C, ARABIC
For details on each type, refer to
“Type (Part Scale Tune
Type)”
(p. 58).
Tune C–Tune B (Patch Scale Tune C–B)
Make scale tune settings for Patch mode.
VALUE:
-64–+63
JUNO-D_e.book 91 ページ ２００４年６月１１日 金曜日 午後１時２１分
To Next Page
Loading...
Need help?
General
